欧美一二区在线观看I性欧美色图I久久九色I国产精品乱码一区二区视频I亚洲色图21pI天堂av资源网I最新日韩中文字幕I亚鲁鲁国产I香蕉网站视频I在线观看污I久久1024I黄瓜视频在线观看I在线中文字幕一区I激情欧美在线观看I国产波霸爆乳一区二区I在线啪I久久久久亚洲av成人无码电影I色婷婷777777仙踪林I毛片在哪里看I狠狠干夜夜干I殴美一级特黄aaaaaaI欧美性激情I可以看的av网站I成年人网站视频免费看I日韩午夜高清I福利视频免费

The LCD splicing screen is not installed like an ordinary display device, but it is simply installed. The installation of the LCD splicing screen should not only be careful to choose the installation site, but also pay attention to the light around the installation environment, and also pay attention to the wiring, and also have requirements for the frame, choose. Let's talk about how to install the LCD splicing screen.

Method / step

The choice of installing the ground:

The installation surface of the LCD splicing screen should be flat, because the entire system of the LCD splicing screen is relatively large in terms of volume and weight. The selected ground also needs to have a certain ability to withstand weight. If the floor is tiled, it may not be able to withstand its weight. Another point is that the installed ground should be able to prevent static electricity.

Wiring precautions:

When installing the LCD splicing screen, be careful to distinguish the power and signal lines when wiring, and install them in different places to avoid interference. In addition, according to the size and installation position of the screen of the entire project, calculate the length and specifications of the various lines required, and calculate the needs of the entire project.

Ambient light requirements:

Although the brightness of the LCD splicing screen is very high, it is still limited, so the light around the environment where the installation is selected should not be too strong. If it is too strong, the screen may not be visible. Light that may be incident near the screen (such as a window), if necessary, should be blocked, and the light should be turned off when the device is running to ensure the normal operation of the device. Do not install the lamp in front of the screen, install the drum light.

Framework requirements:

In order to facilitate the maintenance of the LCD splicing screen in the future, the frame edging must be detachable. In the outer frame, a gap of about 25 mm is reserved on each side of the outer wall of the wall, and the large wall should also be appropriately increased according to the number of columns. In addition, in order to enter the cabinet maintenance later, the maintenance passage is in principle not less than 1.2m wide. The detachable side strip is suitable for pressing the edge of the screen by 3-5 mm. After the box and the screen are completely installed, the detachable side strip is finally fixed.